HP Integrity rx4610 Server - Manual (Page 101)

Chapter 10: Configuring the HP Server
94
Fault Resilient Booting (FRB) Setup
Fault Resilient Booting (FRB) allows a multiprocessor system to boot in case the bootstrap processor
(BSP) fails.
FRB3 Timeout
FRB3 refers to the level of FRB in which a timer is started at system power up or hard reset. The
BIOS stops this timer in the power-on self test (POST) by asserting the FRB timer halt signal to the
Bus Management Controller (BMC). If the timer is not stopped, the BSP is disabled, the system is
reset and another processor becomes the BSP.
This edit box lets you set the FRB3 timeout in seconds. The range is 0 to 65535 seconds. The
recommended setting is 180 seconds.
Advanced Configuration Power Interface (ACPI) Setup
ACPI Setup provides the ability to configure the ACPI features described below:
ACPI Feature Description
Button Model Sets the power and/or sleep button model used by the
system:
• Power Button Only. The system supports a
single power button. This is the default.
• Power and Sleep Buttons. The system
supports both power and sleep buttons.
State Notify Specifies whether other server management
controllers in the system will be notified upon
ACPI power state changes:
• Enable. Enables notification.
• Disabled. Disables notification. This is the
default.
Fan Control Controls fan operation when the system enters the S1
sleep state:
• Do Not Stop Fans. Fans continue to run when
the system enters a sleep state. This is the
default.
• Stop Fans. Stops fans on a sleep state.
Platform Event Filtering (PEF) Setup
Platform Event Filtering is used to configure the actions taken when certain platform events occur.
You must select <Save> in the PEF Setup page to actually set the filter entries.
The available event filters are:
PEF Feature Description
PEF Enable Enables or disables Platform Event Filter (PEF).
Default=Enabled
Logging Enable Enables or disables system event logging when an event
filter is triggered. Default=Enabled