HP LaserJet Pro CP1525nw Color Printer - Manual (Page 137)

Control panel message Status alert Description Recommended action
Misprint
Press [OK]
Paper has been delayed as it
moves through the product. Press OK to clear the message.
Non HP supply installed A non-HP supply is installed. If you believe you purchased an
HP supply, go to
www.hp.com/
go/anticounterfeit .
Service or repairs that are
required as a result of using non-
HP supplies are not covered
under HP warranty.
Print failure
Press [OK] If error repeats turn
off then on
The product cannot process the
page. Press OK to continue printing the
job, but output might be affected.
If the error persists, turn the
power off and then on. Resend
the print job.
Rear door open The product rear door is open. Close the door.
Remove shipping locks from
<color> cartridge A print cartridge shipping lock is
installed. Be sure that the print cartridge
shipping lock has been removed.
Remove shipping locks from
all cartridges A print cartridge shipping lock is
installed on one or more print
cartridges. Be sure that each print cartridge
shipping lock (orange pull tab on
the left end of new print
cartridges) has been removed.
Replace <color> The print cartridge is at the end of
its useful like, and the At Very
Low menu item in the System
Setup menu is set to Stop. To ensure optimal print quality,
HP recommends replacing the
print cartridge at this point. You
can continue printing until you
notice a decrease in print quality.
Actual cartridge life may vary.
Once an HP supply has reached
"very low", HP's premium
Protection Warranty on that
supply has ended. All print
defects or cartridge failures
incurred when an HP supply is
used in continue at very low
mode will not be considered to be
defects in materials or
workmanship in the supply under
the HP Print Cartridge Warranty
Statement.
Supplies low More than one supply item is low. Check the supply level gauges on
the control panel, or print a
supplies status page to
determine which print cartridges
are low.
Printing will continue until a ”Very
Low” message displays.
Consider having replacement
supplies on hand.
Unexpected size in tray #
Load [size] Press [OK]
The product has detected paper
in the tray that does not match the
configuration for the tray. Load the correct paper into the
tray, or configure the tray for the
size that you have loaded.
ENWW Interpret control panel messages 123