HP XP Performance Advisor Software - Manual (Page 42)

–metric <Category> Constrains the output by the metric category. Valid values are as follows:
IO_TOTAL - LDEV IO Total
IO_RAND_TOTAL LDEV – IO Random Total
IO_RAND_READ LDEV - IO Random Read
IO_RAND_READ_CACHE LDEV – IO Random Read Cache Hits
IO_RAND_WRITE LDEV – IO Random Write
IO_RAND_WRITE_CACHE
LDEV IO Random Write Cache Hits
IO_SEQ_TOTAL LDEV IO Sequential Total
IO_SEQ_READ LDEV IO Sequential Read
IO_SEQ_READ_CACHE LDEV IO Sequential Read Cache Hits
IO_SEQ_WRITE LDEV IO Sequential Write
IO_SEQ_WRITE_CACHE LDEV
IO Sequential Write Cache Hits
MB_TOTAL LDEV MB Total
MB_RAND_TOTAL LDEV MB Random Total
MB_RAND_READ LDEV MB Random Read
MB_RAND_WRITE LDEV MB Random Write
MB_SEQ_TOTAL LDEV MB Sequential Total
MB_SEQ_READ LDEV MB Sequential Read
MB_SEQ_WRITE LDEV MB Sequential Write
CFW_TOTAL LDEV IO type
CFW_READ LDEV IO type
CFW_READ_CACHE LDEV IO type
CFW_WRITE LDEV IO type
CFW_WRITE_CACHE LDEV IO type
DFW_COUNT LDEV IO type
DFW_NRML_COUNT LDEV IO type
DFW_SEQ_ACCESS LDEV IO type
DFW_WRITE_HITS LDEV IO type
DFW_SA_WRITE_HITS LDEV IO type
CACHEMODE_INHIBIT LDEV IO type
CACHEMODE_BYPASS LDEV IO type
PORT_IO_MAX Port Maximum IO/s
PORT_IO_MIN Port Minimum IO/s
PORT_IO_AVE Port Average IO/s
PORT_MB_MAX Port Maximum MB/s
PORT_MB_MIN Port Minimum MB/s
PORT_MB_AVE Port Average MB/s
FBUS_HI DKC Bus Utilization
FBUS_LO DKC Bus Utilization
MBUS_HI DKC Bus Utilization
MBUS_LO DKC Bus Utilization
BACKEND_SEQ_READ LDEV Backend
BACKEND_NONSEQ_READ LDEV Backend
BACKEND_WRITE LDEV Backend
THP Pool Occupancy
Snapshot Pool Occupancy
–mval <Item Value> Constrains the output by the item value, for example an LDEV or Port ID.
–st <mm.dd.yyyy
hh:mm:ss>
Constrains the output by a certain start time.
–et <mm.dd.yyyy
hh:mm:ss>
Constrains the output by a certain end time.
–tclass <Time Class> The class for the time constraints. Valid arguments are: posted Time is constrained by the
posted time. updated Time is constrained by the updated time. dispatched Time is constrained
by the updated time.
–pf <password file> Can be used in place of –auth.
NOTE:
The password file must be created using the encrypt command only.
42 Reporting and configuring CLUI shell scripts