HP LaserJet Pro CM1415fnw Color Multifunction Printer - Manual (Page 234)

Control panel message Description Recommended action
Load Tray 1 <TYPE> <SIZE>, Press OK to
use available media Device is processing a job, but no trays
match. Load paper in the correct orientation.
Touch the OK button to use existing tray
settings.
Load Tray 1, <PLAIN> <SIZE> / Cleaning
mode, OK to start Cleaning mode paper prompt. Load a clean sheet of paper in the correct
orientation, then touch the
OK button to begin
the cleaning procedures.
Magenta Cartridge Low The print cartridge is nearing the end of its
useful life. Printing can continue, but consider having a
replacement supply on hand.
Magenta in wrong position The print cartridge is installed in the incorrect
slot. Make sure that each print cartridge is
installed in the correct slot. From front to
back, the print cartridges are installed in this
order: black, cyan, magenta, and yellow.
Magenta Very Low The print cartridge is at the end of its useful
life, and the
At Very Low menu item in the
System Setup menu is set to Continue .
To ensure optimal print quality, HP
recommends replacing the print cartridge at
this point. You can continue printing until you
notice a decrease in print quality. Actual
cartridge life may vary.
Once an HP supply has reached “very low”,
HP's premium Protection Warranty on that
supply has ended. All print defects or
cartridge failures incurred when an HP supply
is used in continue at very low mode will not
be considered to be defects in materials or
workmanship in the supply under the HP Print
Cartridge Warranty Statement.
Manual Duplex Load Tray 1, Press OK Manual duplex mode. Load paper in the correct orientation.
Manual feed <SIZE> <TYPE>, Press OK to
use available media Print Manual Feed mode. Load paper into Tray 1.
Memory is low Try again later The product does not have enough memory
to start a new job. Wait until the current job is finished before
starting a new job.
Turn the product off and then on to clear the
memory.
Memory is low. Press OK. The product memory has been almost
completely filled. Touch the OK button to cancel the job.
Break the job into smaller jobs that contain
fewer pages.
Turn the product off and then on to clear the
memory.
Memory low Only 1 copy made. Press OK
to continue. The product does not have enough memory
to complete the collated copy job. Break the job into smaller jobs that contain
fewer pages.
Turn the product off and then on to clear the
memory.
Misprint, Press OK Feed delay misprint. Verify that paper is loaded in the input tray.
Reload paper.
Table 13-1 Control-panel messages (continued)
218 Chapter 13 Solve problems ENWW