HP XP P9500 Storage - Manual (Page 260)

If you want to specify the output destination for audit log data, first specify
the audit log facility by using the dlnkmgr set -audfac command. Next,
define the output destination of the facility in the /etc/syslog.conf file.
Table 3-62 Values Indicating Audit Log Facility on page 3-192 describes the
values that indicate audit log facility. The default is user.
Table 3-62 Values Indicating Audit Log Facility
Value Corresponding facility value in the /etc/syslog.conf file
user or 1 user
local0 or 16 local0
local1 or 17 local1
local2 or 18 local2
local3 or 19 local3
local4 or 20 local4
local5 or 21 local5
local6 or 22 local6
local7 or 23 local7
This example shows how to specify the audit log facility:
# /opt/DynamicLinkManager/bin/dlnkmgr set -audfac local0
Checking the Updated Settings
This chapter describes steps involved in how to check the new settings by
using the dlnkmgr command's set operation after the new settings are
applied.
When you some these settings, you can display information about all of HDLM
function settings. The following is an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -sfunc
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster :
Elog Level : 2
Elog File Size(KB) : 1000
Number Of Elog Files : 5
Trace Level : 1
Trace File Size(KB) : 2000
Number Of Trace Files : 10
Path Health Checking : on(10)
Auto Failback : on(10)
Reservation Status :
Intermittent Error Monitor : on(2/20)
KAPL01001-I The HDLM command completed normally. Operation name =
3-192
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Linux(R))