HP ProLiant ML570 G4 Server - Manual (Page 26)

Operations 26
3. Remove the tower bezel if necessary.
Remove the rack bezel
The rack bezel must remain installed during normal server operations. The rack bezel remains installed for
all hardware options installations, except for the following situations:
• Removing or replacing a SAS hard drive cage
• Converting the server from a rack model to a tower model
To remove the rack bezel:
1. Extend or remove the server from the rack (" Extend the server from the rack " on page 23 ).
2. Remove the tape drive blank or the tape drive.
3. Using the Torx T-15 screwdriver, remove the three screws on each side of the rack bezel.
4. Push down on the latch connected to the media bay.