HP ProLiant BL490c G7 Server-Blade - Manual (Page 34)

Hardware options installation 34
12. Remove the thermal interface media protective cover.
CAUTION: To avoid damage to the system board, processor socket, and screws, do not
overtighten the heatsink screws. Use the wrench supplied with the system to reduce the possibility
of overtightening the screws.
CAUTION: To avoid possible thermal damage, install replacement heatsinks as indicated on the
heatsink labels. The heatsinks are not interchangeable between processor 1 and processor 2
within a server blade.
13. Install the heatsink. Insert both screws, and then alternate tightening until the heatsink is seated properly.
14. Install the DIMM baffle.
15. Connect the hard drive cables (" Hard drive cabling " on page 40 ).
16. Install the access panel (on page 13 ).
17. Install the server blade (" Installing a server blade " on page 17 ).