HP Deskjet 832c Printer - Manual (Page 57)

50
Creative Printing 3
After you are done printing:
1 Flip the banner switch down.
2 Put paper into the IN tray.
What if the banner has a big gap or a crease where you don’t expect it?
• The printer might be picking up more than one sheet of paper at a time. Take
the paper out, then fan the stack. Also be sure the top and bottom margins are
set to zero in your banner program. Print the banner again.
• The software program from which you printed may need to be set to print on a
continuous sheet instead of individual pages. See the manual provided with
your software program.
What if the banner paper jams in the printer?
• You might not have clicked a Banner paper type in the Page Setup dialog.
• Put in more than five, but fewer than 20, sheets of paper.
• Make sure the banner switch (located on the printer) is up.
• See the online ReadMe file for the appropriate settings for specific software
programs.
• Make sure you remove all paper before loading the banner paper.
What if you get a message that says you’re out of paper, but you’re not?
You might not have pushed the paper-length adjuster in all the way. Make sure
it’s snug against the paper, and print again.
What if the text is fuzzy after printing a banner?
If the print quality seems especially poor when you switch from banner
printing, you might have forgotten to reset the printer for normal printing.
C6411-90053_VeniceFixed.book Page 50 Monday, June 28, 1999 11:50 AM