HP OmniBook 3000 Notebook PC - Manual (Page 7)

Using OmniBook Plug-In Modules
Replacing a Plug-In Accessory Module
1-7
Replacing a Plug-In Accessory Module
Important If you are inserting or removing a CD-ROM or Zip drive, turn the OmniBook off
before removing or inserting the plug-in module (shut down the computer using the
Start menu or press the power button for 4 or more seconds). This is not necessary if
you are inserting or removing a floppy disk drive or secondary battery.
To replace a plug-in module
1. From the Start menu, shut down Windows 95 (for CD-ROM drive or Zip drive
only).
2. Slide the safety latch for the plug-in slot into its recess.
3. Slide and hold the release latch, then pull out the module, as shown.
Safety
latch
Release
latch