HP StorageWorks Scalable File Share User Manual
Page 141
Verifying the system
6–11
3.
Look at the status of each logical disk on the SFS20 array, as follows:
=> ld all show
MSA20 at 01
array A
logicaldrive 1 (1.99 GB, RAID 5, OK)
logicaldrive 2 (1.45 TB, RAID 5, OK)
The status for each logical disk should be set to
OK
.
If there has been a disk failure, the state of the logical disk may be set to
Rebuilding
, as shown in
the following example:
=> ld all show
.
.
.
array A
logicaldrive 1 (1.99 GB, RAID 5, Rebuilding)
4.
View the information for each logical disk, as shown in the following examples:
•
To view all information on a logical disk, enter the command shown in the following example:
=> ld 1 show
MSA20 at 01
logicaldrive 1
Size: 1.99 GB
Fault Tolerance: RAID 5
Heads: 255
Sectors per Track: 32
Cylinders: 514
Stripe Size: 256 KB
Status: Ok
Array Accelerator: Enabled
Disk Name: Unknown
Mount Points: Unknown
•
Alternatively, if you only want to check the status of the logical disk, enter the command shown
in the following example:
=> ld 1 show status
logicaldrive 1 (1.99 GB, RAID 5): Ok
The status of the logical disk should be set to
OK
.
Repeat this step for each logical disk.
5.
View information on the disk groups, by entering the following command. Within the
hpacucli
tool,
a disk group is called an
array
:
=> array all show
MSA20 at 01
array A (SATA, Unused Space: 0 MB)
6.
View information on an individual disk group, by entering the command shown in the following
example:
=> array A show
MSA20 at 01
array A
Interface Type: SATA
Unused Space: 0 MB
Status: OK
The status of the disk group should be set to
OK
.