Transparencies – HP Deskjet 6943 Printer User Manual
Page 58
7.
Replace the Out tray.
Print
1.
Open the
dialog box, and then select the following settings:
–
Paper Size: The appropriate card size
–
Orientation: The appropriate orientation
Note
To print a borderless card, click the borderless photo size that
matches the card size.
2.
Click OK.
3.
Open the
dialog box.
4.
Select the Paper Type/Quality pane, and then specify the following settings:
–
Paper Type: The appropriate card type
–
Quality: Normal, Best, or Maximum dpi
5.
If you want to use them, set the
HP Real Life digital photography options
6.
Select any other print settings that you want, and then click Print.
Note
If an out-of-paper message appears, verify that the cards are positioned
correctly in the paper tray.
Transparencies
Guidelines
Do not exceed the In tray capacity: 30 transparencies.
Prepare to print
1.
Verify that the printer is turned on.
2.
Raise the Out tray, and then remove all paper from the In tray.
3.
Slide the paper-width guide all the way to the left, and then pull out the paper-length
guide.
4.
Place the transparencies in the In tray.
The side to be printed on should face down and the adhesive strip should face up
and toward the printer.
5.
Carefully push the transparencies into the printer until they stop, so that none of the
adhesive strips catch on one another.
Chapter 7
56
HP Deskjet 6940 series