HP ProLiant ML310 G2 Server - Manual (Page 51)

Hardware Options Installation 51
4. Install the SAS controller, and press it down to seat.
5. Disconnect the SAS cable from the system board and connect it to the SAS
controller.
6. Be sure the SAS cable is properly connected to the SAS controller and drive
backplane.
Removing the CD-ROM Drive
Before installing the drive option kit, the CD-ROM drive must be removed.
To remove the component:
1. Power down the server.
2. Remove the access panel ("Removing the Access Panel" on page 22 ).
3. Disconnect the cables from the rear of the CD-ROM drive.