Installation instructions, Caution, Window requirements – GE AEN10AQ User Manual

Page 9: Storm window requirements, Remove the air conditioner from the case

Advertising
background image

Installation Instructions

WINDOW REQUIREMENTS

• These instructions are for a standard

double-hung window. You will need to modify

them for other types of windows.

CAUTION:

If the sill support

bolts do not contact the window sill, or

if you have a window without a sill, you

must order accessory kit RAK87 to

properly install this air conditioner.

Call 800.626.2002 or visit GEAppliances.com.

• The air conditioner can be installed without

the accordion panels if needed to fit in a

narrow window. See the window opening

dimensions.

• All supporting parts must be secured

to firm wood, masonry or metal.

• The electrical outlet must be within reach of

the power cord.

1

16.4” min.

25.25s to 38s

(With accordion panels)

STORM WINDOW REQUIREMENTS

A storm window frame will not allow the air

conditioner to tilt toward the outside, and will keep

it from draining properly. To adjust for this, attach

a piece of wood to the sill.
WOOD PIECES –
WIDTH: 2
s
LENGTH: Long enough to fit inside the window

frame.
THICKNESS: To determine the thickness, place a

piece of wood on the sill to make it 1/2s higher

than the top of the storm window frame or the

vinyl frame.
Attach securely with nails or screws provided

by the installer.

2

1/2shigher

than storm

window

frame

Storm window

frame

Wood

Sill

1/2shigher

than vinyl frame

(on some windows)

Vinyl frame

REMOVE THE AIR CONDITIONER

FROM THE CASE

Remove and save the 2 screws from the lower

sides of the front grille.

Grasp the lower corners of the grille while

pressing in on the case sides with your finger

tips. Pull out to release and lift it up.
NOTE: Do not pull the bottom edge toward you

more than 3s or you may damage the tabs of

the grille.

Remove the ground screw from each side

of the case. Keep them in a safe location.

NOTE: Be sure to save these screws. You

will need them later in the installation.

Slide the air conditioner from the case by

gripping the base pan handle and pulling

forward while bracing the case. Do not pull

or lift on the styrofoam discharge area.

3

A

C

FRONT

D

FRONT

Do not

pull or

lift in this

DUHD³

damage

to the

unit may

result

FRONT

FRONT

B

9

Advertising
This manual is related to the following products: