GE JVM6175DFWW - Manual (Page 17)

AFTER: Fan Blade
Openings Facing Back
7 Place the blower unit back into the opening.
Roll the blower unit 90° so that fan blade
openings are facing out the back of the
microwave.
5
4
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST (cont.) B4.
17
Rotate blower unit counterclockwise 180°.
Before Rotation After Rotation
Gently remove the wires from the grooves.
Reroute the wires through grooves on other side
of the blower unit.
Before Rerouting After Rerouting
Wires Routed Through Right Side Wires Routed Through Left Side
Back of
Microwave
Oven Back of
Microwave
Oven
Before Rolling After Rolling
End A
End B
Back of
Microwave
Oven
Back of
Microwave
Oven
CAUTION:
Do not pull or
stretch the blower unit wiring. Make sure the
wires are not pinched.
NOTE: The blower unit exhaust
openings should match exhaust
openings on rear of microwave oven.
Installation Instructions
6
Slide the exhaust adaptor onto the back
of the microwave oven, securing it into the
lower locking tabs. Take care to ensure that
the damper hinge is installed so that it is at
the top and that the damper swings freely.
Reinstall the upper blower motor screw
through the adaptor and the blower door
and into the back of the microwave oven.
Close the blower door and secure it using
the screw from Step 1.
8 Secure the blower to the microwave oven
using the retaining screw from Step 2.
9
Guide
Guide
Adaptor
Locking Tabs
(not shown)
Back of
Microwave Oven
Blower Motor
Door Retaining
Screw
Back of
Microwave
Oven
Blower
Blower
Retaining Screw
Blower
Retaining
Screw