GE AEQ12DQ - Manual (Page 10)

installation instructions
5
A
B
2 Frame locking brackets
PRePARe THe WinDoW
Cut the window sash seal to the proper
length. Peel off the backing and attach the
seal to the underside of the window sash.
4 6
inSTALL SuPPoRT BRACKeT AnD
foAM ToP WinDoW gASKeT
Cut the foam top window gasket to the window
width .
Stuff the foam
between the glass
and the window
to prevent air and
insects from getting
into the room .
NOTE: If the gasket supplied does not fit your
window, obtain appropriate material locally to
provide a proper installation seal .
A CAuTion:
To prevent broken glass or
damage to windows, on
vinyl or other similarly
constructed windows,
attach the window locking
bracket to the window
side jamb with one screw.
B
C
Wood
Vinyl
3 Screws
C
10
inSTALL THe AiR ConDiTioneR in
THe WinDoW
Place the air conditioner on the sill with the
bottom mounting rail against its back edge .
Center it and close the window securely behind
the top mounting rail .
It should be level or slightly tilted to the outside .
Use a level; about a 1/3 bubble will be the correct
case slant to the outside .
Extend the left and right accordion panels to
the vertical window sashes and attach 3 screws
through the holes in the upper panels, as
appropriate .
Install the frame locking brackets between the
bottom of the accordion panel and the window
sill . Attach with 2 screws . NOTE: To prevent the
window sill from splitting, drive the pilot holes
before driving the screws .