GE PW9000SFSS - Manual (Page 12)

Parts provided: 4 Wood screws
Place carton on a flat surface.
Open one end of the carton and lift off the top piece.
Lift the warming drawer up and out of the carton.
Place the drawer on top of the shipping carton to protect
the drawer front and the finished flooring.
Remove all packing materials and tape.
Locate package containing 4 wood screws and set aside.
Installation Below a Countertop
„ When installed, the front face of the warming drawer will be
nearly flush with cabinetry doors or drawer fronts.
„ Drawer overlaps will conceal cut edges on all sides of the
opening.
The rough opening for the drawer must be:
³'HSWK 23
1 ø 2
” minimum from inside back to front of cabinet
frame.
³:LGWK 25 1 ø 2
” for 27" wide models
28 1 ø 2
” for 30" wide models.
³+HLJKW  9 1 ø 4
”
„ 5” minimum above floor or 1" above toekick. 23 1 ø 4
” from floor
to bottom of cutout is recommended for under countertop
installation.
Installation below a cabinet drawer:
The warming drawer may be installed beneath a cabinet
drawer. In this installation, a solid barrier should be installed
above the warming drawer to block access. Use any solid
material such as 1/4" thick plywood. Allow at least 1/4" air
gap between the barrier and the top of the warming drawer.
Observe the 5" min. above the floor or 1" above the toekick min.
installation height.
NOTE: If you are installing in frameless cabinets, it may be
necessary to install 1/2" wide cleats to accept drawer mounting
screws. See drawer to find exact locations of mounting screws.
When installed under a cooktop:
Warming drawers are suitable for installation below only certain
specified cooktop models. See the label attached to the top of
the warming drawer for suitable models. A solid barrier and air
gap between cooktop and warming drawer is required. See
Note above.
12
Installation of the warming drawer.
Read these instructions completely and carefully.
Remove Packaging and Parts
Electrical outlet 42"
max. from right side
1" Min.*
25"
9"
9 1 ш 4
”
23 1 ш 2
” Min.
36"
Countertop
height
Electrical
outlet 16” max.
from left side
Electrical outlet
flush with side of
cabinet 7" max.
Install 2x4 or 2x2
anti-tip block against
rear cabinet wall 9”
from floor to bottom
of block
7"
1 1 ø 2
” Cabinet top
Install a solid barrier
and a 1/4” min. air
gap above warming
drawer
1/4” Air gap
Solid barrier
Install a solid barrier below
a cooktop (see Note)
IN CANADA THIS DRAWER IS NOT
APPROVED FOR INSTALLATION
UNDER A COOKTOP.
*NOTE: When installing the warming drawer below a cooktop, a solid
barrier must be installed at least 1"from the lowest point of the bottom
of cooktop burner box to the top of cutout. Use any solid material such as
1/4" thick plywood. Allow at least 1/4"air gap between the barrier and the
top of the warming drawer. See label on top of the wa rming drawer for
approved cooktop models.
Dimension A
27 " Drawer 30 " Drawer
25 1 ш 2
” 28 1 ш 2
”
CAUTION