GE PGP989DNBB User Manual
Pgp989dn/tn, Ge profile, Series 30" downdraft gas cooktop
Dimensions and Installation Information
Listed by
Underwriters
Laboratories
For answers to your Monogram
®
or GE
®
appliance
questions, visit our website at geappliances.com
or call GE Answer Center
®
service, 800.626.2000.
Specification Revised 3/13
230284
*Note: A 5" minimum spacing to adjacent side wall is required
Dimension and installation information are shown in inches.
Wall Installation: Wall installations require 25”
countertop depth. When cabinet is flush against
the wall, the fan housing can be rotated to the
horizontal position for direct venting through
rear wall. Make a countertop cutout in the
range cabinet according to unit dimensions
and installation type. Duct hole is positioned in
back of cabinet for through-the-wall ducting.
Requires special offset adapter JXRW89.
Peninsula or Island Installation: For peninsula/
islands a minimum 26” countertop depth is suggested.
Blower should be in vertical position. Island or
peninsula cabinets may require adjustment in cutout
depth and/or location within the width dimensions.
Duct hole is positioned in bottom of cabinet for island
or peninsula installation.
Slab Installation: For peninsula or island installation
and rear wall ducting,
6” PVC duct or locally
approved piping should be used if installing under
a poured concrete slab.
Installation Information: Before installing, consult
installation instructions, packed with product, for
current dimensional data.
Note: These cooktops are approved for indoor use only.
40
Long
20
9
4
10-1/2
16
CL
Cabinet Dimensions (in inches)
22
7
⁄
16
ʺ
(22
9
⁄
16
ʺ SS)
20
1
⁄
2
ʺ
22ʺ
29
7
⁄
8
ʺ
(30ʺ SS)
2
3
⁄
16
ʺ
(2
1
⁄
4
ʺ SS)
28
3
⁄
4
ʺ
25
1-7/8"
MIN. Required*
20-5/8
Cut-out Dimensions (in inches)
28-7/8
*U.L. Requirement.
Note: A 5" minimum spacing to adjacent side wall is required
PGP989DN/TN
GE Profile
™
Series 30" Downdraft Gas Cooktop
22
7
⁄
16
ʺ
(22
9
⁄
16
ʺ SS)
20
1
⁄
2
ʺ
22ʺ
29
7
⁄
8
ʺ
(30ʺ SS)
2
3
⁄
16
ʺ
(2
1
⁄
4
ʺ SS)
28
3
⁄
4
ʺ
25
1-7/8"
MIN. Required*
20-5/8
Cut-out Dimensions (in inches)
28-7/8
*U.L. Requirement.
Note: A 5" minimum spacing to adjacent side wall is required