GE ZSC1202NSS - Manual (Page 4)

monogram.com
25
Abov
e-the-cook
top
A
dv
antium
Speedcook
ov
ens
m
icr
ow
av
e ov
ens
m
icr
ow
av
e ov
ens
w
arming draw
er
s
A
dv
antium
®
Speedcook
w
all ov
ens
The Monogram Advantium 120 built-in oven can be installed
directly into a wall or a 27"- or 30"-wide wall oven cabinet.
Install it alone, with a wall oven or with a warming drawer.
• This oven must be installed at least 36-3/4" above the floor.
• For personal safety, this oven cannot be installed in a cabinet
arrangement such as an island or peninsula.
• This oven is not approved for installation below a
countertop, side by side or stacked.
Electrical requirements
Product rating is 120V, 60Hz, 15-amp circuit and draws 1.8
kilowatts. It must be connected to a supply circuit of the proper
voltage and frequency and protected by a time-delay fuse or
circuit breaker.
Cutout and product dimensions
Advantium 120 oven installed alone
Order a 27"- or 30"-wide single oven cabinet or cut the opening
in a wall to the dimensions shown.
Advance planning for wall ovens with 27"/30" Advantium 120
Speedcook technology
Advantium 120 oven installed above a Monogram
single wall oven
When installed over a single oven or a warming drawer, allow at
least 2" between the two openings. This separation will provide
clearance for bottom overlap of the Advantium oven and top
overlap of the single oven or warming drawer.
• The Advantium 120 oven and single oven combination
must be supplied with separate electrical connections.
Note: Additional
clearance between
cutouts may be
required. Check to
be sure the oven
supports above the
warming drawer
location do not
obstruct the required
interior depth and
height. See each
specific product’s
installation instructions
for details.
27" or 30" 23-1/2"
17-1/2"
45-1/4"
Min.
Construct Solid
Bottom Min. 3/8"
Plywood
Supported by
2 x 4 or 1 x 2
Runners, all
Four Sides
2" Min.
Per Oven
Requirement
2" Min.
9-1/4"
25-1/8" Min.
25-1/4" Max.
Advantium 120 oven installed above a Monogram
single wall oven and a warming drawer
An anti-tip block must be installed at the rear of the warming
drawer opening. See installation instructions for complete details.
• The warming drawer and the Advantium 120 oven must be
supplied with separate 120V, 60Hz, properly grounded receptacles.
The middle rail
separating the
two openings
may need to be
larger than the 2"
min. shown.
Advantium 120 oven installed above a Monogram
warming drawer
An anti-tip block must be installed at the rear of the
warming drawer opening. Again, see installation
instructions for complete details.
• The warming drawer must be supplied with a separate
120V, 60Hz, properly grounded receptacle.
36-3/4"
Min.
Construct Solid
Bottom Min.
3/8" Plywood
Supported by
2 x 4 or 1 x 2
Runners, all
Four Sides
2" Min.
Install 2 x 4
or 2 x 2
Runners or
Solid Bottom,
Must Support
100 lbs.
17-1/2"
9-1/4"
27" or 30" 23-1/2"
25-1/8" Min.
25-1/4" Max.
27" or 30" 23-1/2"
36-3/4"
Min.
45-1/4"
Recommended
Construct Solid
Bottom Min. 3/8"
Plywood
Supported by
2 x 4 or 1 x 2
Runners, all
Four Sides
2" Min.
Per Oven
Requirement
17-1/2"
25-1/8" Min.
25-1/4" Max.
The middle rail
separating the two
openings may need to
be larger than the
2" min. shown.
Electrical location
Locate a recessed outlet within
6" of either side and at least 9"
above the cutout floor.
The serial plate is located
on the oven cavity flange,
behind the door.
17-1/2"
36-3/4"
Min.
27" or 30"
25-1/8" Min.
25-1/4" Max.
26-3/4"
23-1/2"
18-5/8"
21-1/2"
29-3/4"
with side trim
18-5/8"
6"
9"
Locate Outlet Box in
the Shaded Area
Construct Base
Min. 3/8" Plywood
Supported by 2 x 4 or
1 x 2 Runners
all Four Sides
17-1/2"
36-3/4"
Min.
27" or 30"
25-1/8" Min.
25-1/4" Max.
26-3/4"
23-1/2"
18-5/8"
21-1/2"
29-3/4"
with side trim
18-5/8"
6"
9"
Locate Outlet Box in
the Shaded Area
Construct Base
Min. 3/8" Plywood
Supported by 2 x 4 or
1 x 2 Runners
all Four Sides
(Recessed
portion)