Loading tips and suggestions, Removing full extension drawers, Wood drawer fronts – GE ZDOD240PLSS User Manual

Page 11: Controls and features

Advertising
background image

Loading
tips and
suggestions

The bottom two full extension drawers hold
five bottles each and are loaded with necks
facing the rear. Tall bottles should not be
loaded on the bottom drawer because
they may prevent the door from closing.

• Do not block the thermistor, located on

the right-hand side, just above the third
shelf of the outdoor/indoor refrigerator.
Blocking the thermistor could impair the
air circulation and temperature control.

Bottom drawer arrangement

Removing
full extension
drawers

The bottom full extension drawers pull
out so bottles can conveniently be added
or removed.

The upper full extension slide can be
removed for magnums or larger bottles.

To remove:

1. Pull the full extension drawer out to

the STOP position.

2. Push the tab on right drawer guide down

while pulling the tab on left guide up, and
pull the drawer out.

To replace:

1. Push the drawer slide arm back into

the unit.

2. Pull the small slide sub-assembly

completely forward.

3. Insert the sides of the drawer back

into the guides.

4. Push until the tabs lock into place.

Tab (push tab down on right
drawer guide, pull tab up on
left drawer guide)

Wood
drawer
fronts

The full extension drawer fronts on
the outdoor/indoor refrigerator are
unfinished cherry wood. During use,
oil from hands may accumulate and
stain the wood.

The drawer fronts may be stained and

sealed to match adjacent cabinetry.

Apply the stain and sealer according to

the manufacturer’s instructions. To avoid
unpleasant odor, keep the door open to
ventilate and allow the stain/sealer to dry
completely before using the product.

NOTE: Natural wood may vary slightly in
grain and color.

NOTE: Make sure the tabs on the full
extension drawer guides are fully engaged
before loading any bottles. Pull the drawers
out all the way to the STOP position and
push back in several times to make sure
locking tabs are properly engaged.

To replace, push drawer
slide arm back into unit

Pull small slide sub-assembly
completely forward

Appearance may vary

11

Controls and Features

Outdoor/Indoor Refrigerator

Sub-assembly

Sub-assembly

Advertising
This manual is related to the following products: