Apple IEEE1394 - Manual (Page 18)

- 12 -
SOFTWARE INSTALLATION FOR WINDOWS XP
1. Boot-up your computer into Windows
XP, making sure the ‘IEEE 1394 Host
Controller’ device driver has been
installed and is available. To check
this, right-click ‘My Computer’, click
‘Properties’ then ‘Hardware’ and then
‘Device Manager’ to open the ‘Device
Manager’ window. Refer to the figure shown alongside to see if the IEEE 1394 Host Controller is
installed without error.
2. Ensure the IEEE 1394 interface cable and then the AC adapter connections are made as described
in Hardware Installation. Insert the port connector of the IEEE 1394 cable into the IEEE 1394 port
of your computer.
3. Windows XP will install its resident device driver automatically. After the installation, you will
find a new drive letter has been assigned for the drive in ‘My Computer’.