American Fibertek RD-20D AFINETY - Manual (Page 9)

9
MONITOR Menu
UNITS - List all Model Numbers of units in the rack by slot #
UNIT n - Lists the monitored parameters and values for the unit in slot “n”
UNITNAME n – Set the name of the card for identification purposes. On the web
browser interface, this appears under the Card ID.
ALARMS – Presents number list of all rules currently programmed to test for
alarm conditions
DELALARM n – deletes the specified alarm rule
ADDALARM n – adds a new rule to the list of alarm rules. See the section on
alarms for alarm rule formatting
RESET – erases all alarm rules and replaces them with the default alarm
conditions. This takes about a minute, during which time the unit will not be able
to do anything else.
TEMPMODE n – used to specify if temperatures are displayed in Celsius or
Fahrenheit notation.
TIMEOUT n – sets the time after which a unit removed from the rack will be
removed from the GUI display.
EMAIL Menu
CONFIG – Shows the current configuration.
DOMAIN n – Enters the source domain name to be used when sending email
notifications.
EMAIL n – Email address to send notifications.
RETRY n – Sets the number of retries that the units attempts to send emails
Default value = 10.
DELAY n – Sets the delay time in seconds between email attempts. Default
value = 900 seconds.
START – Starts the email notification system.
STOP – Stops the email notification system.