American Fibertek MRX-986-UTP-SL - Manual (Page 10)

10
MTX-986-UTP-SL STATUS INDICATORS (cont)
OLI 1
A bi-color LED indicator monitors the optical input power of the data signal that is being
received at the MTX-986-UTP-SL from the MRX-986-UTP-SL. Optical input status associated
with this LED is summarized below.
OPTICAL LEVEL LED AC Power Status Optical Status
Green On Proper Optical Input Power Present
Red On Optical Input Not Detected
MRX-986-UTP-SL STATUS INDICATORS
The MRX-986-UTP-SL receiver provides the following front panel LED status indicators to aid in
installation and troubleshooting:
DATA RX/TX INDICATORS
DATA RX and DATA TX indicators are provided to monitor each of the two available data
channels. DATA 1 RX and TX correspond with the multi-protocol output/input of DATA CH 1.
DATA 2 RX and TX correspond with the status of the Contact (open/closed).
DATA RX/CONTACT STATUS
A green LED indicator is provided to monitor the data coming in from the fiber, through the
MRX-986-UTP, and out onto the electrical interface. The intensity of this indicator will vary with
input data patterns, however in typical applications it will cycle on and off as data is received.
Data received status associated with this LED is summarized below.
DATA RX LED Data 1 Status Data 2 (Contact) Status
Green Data Flow Present Contact Closed
Off Data Flow Not Detected Contact Open
DATA TX/CONTACT STATUS
A green LED indicator is provided to monitor the data coming in from the electrical interface,
through the MRX-986-UTP, and out onto the fiber. The intensity of this indicator will vary with
input data patterns, however in typical applications it will cycle on and off as data is transmitted.
Data transmitted status associated with this LED is summarized below.
DATA TX LED Data 1 Status Data 2 (Contact) Status
Green Data Flow Present Contact Closed
Off Data Flow Not Detected Contact Open