American Fibertek MRX-986-UTP-SL - Manual (Page 5)

5
VIDEO INPUT / OUTPUT CONNECTIONS
Video input and output connections are located on the rear of the unit. Video input connections
on the MTX-986-UTP-SL are connected to an appropriate baseband video source such as a
camera or a video recorder output. The video outputs on the MRX-986-UTP-SL can be looped
through typical baseband video inputs of switchers, recorders and other equipment as required.
For optimum performance the video cables should be the shortest length of unshielded twisted
pair cable practical. Use the chart and the drawing below to determine the proper configuration
of the UTP connector wires for insertion into the MTX-986-UTP-SL unit. The bottom UTP port
on the MTX-986-UTP-SL corresponds to video channels 1 through 4, the top corresponds to
channels 5 through 8. The video output connectors of the MRX-986-UTP-SL follow the same
orientation and configuration.
DATA INPUT / OUTPUT CONNECTIONS (DATA 1)
Data input and output connections are made via terminal blocks on the back of the unit. See the
drawings below for proper orientation of the input and output connections. Please note that the
far right pin on each connection drawing corresponds with the far right terminal block pin on the
unit.
Please note that Data In on the MTX-986-UTP-SL becomes Data Out on the MRX-986-UTP-SL
after going across the fiber. The reverse flow follows the same orientation.
CONTACT INPUT / OUTPUT CONNECTIONS (DATA 2)
Data input and output connections are made via terminal blocks on the back of the unit. See the
drawing below for proper orientation of input and output connections. Please note that the far
right pin on the connection drawing corresponds with the far right terminal block pin on the unit.
Please note that Contact In on the MTX-986-UTP-SL becomes Contact Out on the MRX-986-
UTP-SL after going across the fiber. The reverse flow follows the same orientation.