American Fibertek RR-91685SL - Manual (Page 4)

4
RT-91685SL COMPONENTS
The RT-91685SL consists of the following components:
1) RT-980-1510
1) RT-CWDM-4 1) SR-20 1) BPS-1
1) RT-980-1530 4) PCSC/UPC-0.3 1) PSR-2 3) BPS-2
1) RT-482-1470/1490
The individual 980 series video rack cards that make up the RT-91685SL are combined in a
rack mount configuration using the SR-20 subrack. Please refer to the instruction manuals for
the SR-20 and the PSR-2 for information on the installation of the subrack with its power supply.
The individual 980 series rack cards can slide into any of the open slots in the SR-20 subrack,
however, the recommended configuration is shown below. This configuration starts with a single
slot blank panel (BPS-1) next to the PSR-2 power supply followed by the RT-482-1470/1490
data card. The RT-CWDM-8 multiplexer continues the configuration which ends with the RT-
980-1510 and the RT-980-1530 video cards moving towards the left side of the rack. The last
six slots in the rack are covered using three dual slot (BPS-2) blank panels. Following this
configuration allows the fiber port on the back of the 980 series cards to best line up with its
associated port on the CDWM unit. Use a small screwdriver to push and lock the ¼ turn
fasteners into place. To maximize the performance and life of the system, installing a fan above
the SR-20 subrack is recommended to pull air up across the RT-91685SL components.
RT-91685SL