EOTech Target Pointer Illuminator Aiming Light - Manual (Page 23)

1-11
1.10 AN/PEQ-2A FEATURES AND CONTROLS (cont’d.)
1.10.1 Illuminator Diffuser Lens Cap. When installed over
the IR Illuminator, spreads the laser energy over an angle
approaching 180 degrees, allowing for illumination of a wider
area. This is useful for illuminating a small room and is most
effective with the IR Illuminator Focus Knob adjusted to the
widest beam (flood) setting.
1.10.2 Infrared Illuminator / Focus Knob. Used with night
vision devices to provide variable focused IR illumination of
the intended target area. The Illuminator Focus Knob is
rotated to vary the illumination beam spread from flood to
spot, based on the range and size of the area to be
illuminated.
1.10.3 Infrared Aim Laser. Used with night vision devices to
provide a precision aim point or to mark targets.
1.10.4 Aim Neutral Density Lens Cap. When placed over
the IR Aim Laser, reduces blooming effects on the target and
is useful for boresighting / zeroing.
1.10.5 Mounting Thumbscrew and Washer. Used to attach
the AN/PEQ-2A to a wide array of mounting brackets,
bracket assemblies, and bracket adapters.
1.10.6 Fire Button. Used to actively emit laser radiation that
corresponds with the position of the Mode Selector.
1.10.7 Illuminator Adjusters. These adjusters can be
rotated in azimuth and elevation to bring the illumination
area over the aiming beam, and can be used to align the IR
Illuminator with the barrel of the weapon.