ADC AD-410 - Manual (Page 82)

7 8
d. Proximity Switch Replacement
1) Discontinue electrical service to the dryer.
2) Remove the two (2) 1/4-20 x 1/2" bolts from
each side of the middle guard and then remove
the guard.
3) Remove the three (3) 1/4-20 x 3/4" bolts from
the bottom guard.
Take notice of the depth of the proximity switch.
4) Unscrew and remove the nut that is on the
bottom of the proximity switch.
5) Install new proximity switch.
6) Set gap between the proximity switch and the
magnet at 3/16" (+/- 1/32").
7) Reinstall middle guard and secure with the bolts
removed in Step #2.
8) Reestablish electrical service to the dryer.
e. Right Load Door Glass (Window) Replacement
1) Remove ALL of the old silicone from around
the door glass.
2) Clean glass door opening (with alcohol) to
remove ALL foreign residue.
3) Carefully clean new door glass with alcohol prior
to installation.
4) Apply a bead of silicone (ADC Part No. 170730)
to the outer perimeter of the door glass opening.
Carefully insert new door glass within door glass
opening.
5) Allow a full 72 hours for the silicone to cure.
6) Trim excess silicone (with razor blade) after cure
time.