Fantasea Line Nano Spotter Light - Manual (Page 5)

5
on the rubber light cover, but it should be attached firmly
to assure that it is watertight and does not allow water to
seep into the cone. The cone is what gives the necessary
buoyancy to the Nano Spotter.
3. Turning the Nano Spotter On/Off
A. It is recommended that you detach the cone from the
flashlight’s head prior to turning the Nano Spotter on/off in
order to prevent tension from being exerted on the cone’s
lanyard.
B. In order to switch the light on, carefully turn the flashlight
head counterclockwise just enough for the light to turn on.
Once the light is turned on, do not keep turning the
flashlight head counterclockwise, or else the
watertight seal of the light will be damaged.
C. In order to switch the light back off, turn the flashlight
head clockwise fashion all through the end. Please note
that there is never a need to use force when closing or
opening the light or turning it on or off.
D. Please note: If you are turning the flashlight head more
than half a turn and nothing happens, you are probably
turning it the wrong way.
4. Assembling the Cone and Multi-Colored Plastic Disks
A. Detach the cone from the flashlight’s head by gently
pulling them away from each other. Make sure that when
separating the cone from the flashlight, there is no tension
exerted on the cone’s lanyard, which is wrapped around
the flashlight.