Fantasea Line Nano Spotter Light - Manual (Page 6)

6
B. Choose one of the colorful plastic disks included with the
kit.
C. Push the chosen plastic disk into the white plastic cone,
until it is positioned inside the dedicated track. Note that
the shiny side of the disk should be positioned towards the
bottom open part of the cone.
D. Cover the flashlight head with the open side of the cone, so
it wraps around it. The cone is held by friction on the
flashlights head.
E. When turned on, the light emits a diffused colorful light.
F. In order to replace the colored plastic disk with a different
colored disk, detach the cone from the flashlight head, and
pull the disk out from the open side of the cone, by gently
pulling the string attached to the disk. Follow steps A-D in
order to insert the new colored disk into the cone.
5. Using the Nano Spotter as a Signaling Device
A. Once the Nano Spotter is turned on, it can be attached to a
diver in order to use it as a signaling device.
B. Tie the flashlight’s hand lanyard to the diver’s equipment.
The best way to do this is to tie the hand lanyard around
the tank valve, where the regulator’s first stage is
connected to the tank.
C. Leave as little slack as possible to the hand lanyard, so the
light is tied to the tank valve as closely as possible.
D. Since the cone consists of positive buoyancy, the Nano
Spotter will be pointing up during the dive.