Fantasea Line Nano Spotter Light - Manual (Page 7)

7
E. After the dive, detach the Nano Spotter from the tank
valve and soak and rinse exterior components in fresh
water.
6. Using the Nano Spotter as a Back-up Light
A. The Nano Spotter can also be used as a back-up light
during night dives. Its compact size means that it can
easily be stored inside a BCD’s pocket and pulled out when
necessary.
B. Prior to the dive detach the cone from the flashlight’s head
by gently pulling them away from each other. Make sure
that when separating the cone from the flashlight, there is
no tension exerted on the cone’s lanyard.
C. To get maximum light you should pull off the cone from
the end of the rubber LED cover and leave it free only
attached to the light by its lanyard, or you can detach the
cone’s lanyard from the flashlight by gently pulling out the
flashlight out of the plastic lanyard’s ring.
D. Make sure batteries are properly installed (see section 1:
Installing and Removing Batteries).
E. After the dive, carefully soak and rinse exterior
components in fresh water.