JELD-WEN JII030 Retractable Patio Door Screens User Manual
Page 2
INSTALLATION INSTRUCTIONS
for Retractable Patio Door Screens (JII030)
2
PRE-DRILL TRACKS
Note!
Laying the
tracks on a scrap piece
of wood will make it
easier to drill through
both sides of the
track.
1. Measure 1/2" from
the cut ends of top
and bottom tracks
and mark on the
scribe line.
2. Drill a 5/32" hole
through both sides
of the tracks at each
mark.
CUT & PRE-DRILL TRaCks - If aPPLICabLE
INCLUDED PaRTs & NEEDED TOOLs
REmOvE PaCkagINg & INsPECT PaTIO DOOR
1
Note!
Tracks are sized for 72" x 80" doors and will need to be cut to
fit 60" x 80" units. Installations of 72" x 80" units can skip to section 2,
“INSTALL TRACKS.”
CUT TRACKS
Note!
The cut end of
the tracks will vary
based on the handing
of the door. When
cutting the tracks, it
is recommended to
cut the end that will
be at the jamb, or
opposite the screen
housing because it
will later be covered
with an end cap.
1. With a hacksaw, cut
6" off of the jamb
end of the top track
and file any rough
edges smooth.
2. The bottom track
has a pre-drilled hole in the center. To keep the hole in the center, cut
3" off of each end.
3. Place an end cap on the exposed jamb end of each track.
scribe Line
Scribe
Line
Exterior side
Shown
1/2"
1/2"
Top
track
End
caps
bottom
track
b
A
D
C
g
F
INCLUDED PARTS
A Screen housing and weatherstrip
b screen tracks
C groove filler shim
D Track end caps
E Handle set
F Magnetic catch assembly
g strike plate and mount
Items not shown:
- 3" flat head screws
- 1 3/4" pan head screws
- 3/4" mill finish flat head screw
NEEDED TOOLS
- Tape measure
- Phillips screwdrivers
- Drill with bits and drivers
(optional)
- scissors
60" DOOR INSTALLATIONS
- Hacksaw
- metal file
- Drill
Cosmetic damage
•
Correct product size. fits either doors sized 72" x 80" or 60" x 80".
•
verify the patio door is square. The diagonal measurements should be
•
the same. maximum allowable deviation from square is 1/8".
E
make sure there is a flat surface on the door frame to mount screen,
•
tracks and magnetic catch.
Correct any deviations before installing the screen.
•