JELD-WEN JII040 Custom Clad Lift and Slide Door Systems - Manual (Page 7)

ASSEMBLY AND INSTALLATION INSTRUCTIONS
for Custom Clad Lift and Slide Door Systems (JII040)
7
INSTALL PANELS
Note! To avoid damage to the rollers, clean all debris from the main
roller track in the sill.
1. Study the overall door configuration before installation. Each panel
will be labeled with a number indicating the order of installation
into the frame and will contain an elevation drawing of the entire
unit. Refer to these drawings and the sections below for detailed
instructions on installing each panel into the frame.
Note! Panels are
not reversible or interchangeable. Two panel doors are shown, but
also apply to three or more panels.
2. If installing a
fixed panel, install
keepers in the
jamb by driving
the provided #10
x 2 1/2 flat head,
square drive screws
(remove keepers
and use #10 x 2
1/2 screws if pre-
installed) through
the keeper, pre-
drilled holes in the
frame and into the
rough opening.
3. Working from
the outside, align
the panel marked
number 1 next
to the frame end
with the interlock
facing the interior.
Place the top of the
first panel into the
exterior most head
track directly over
the corresponding
sill location.
4. Raise the panel and
swing the bottom
in so the wheels are
properly located on
the sill track.
5. Push the panel fully
into the pocket (for
pocketing systems)
or to the fixed panel
jamb (for stacking
systems).
6. If installing a fixed
panel, use either
a handle or 3/8"
ratchet to rotate the
locking mechanism
180 degrees to
secure the fixed
panel to the jamb.
7. Repeat for all remaining panels in sequential order.
6
INSTALL DOOR - CONTINUED
FOLLOWER AND POCKET CLOSURE (POCKETING SYSTEMS ONLY)
1. From interior side
of system, slide the
follower over the
bolt heads located
at the back edge
of the last panel
and align so that
the weatherstrip is
tight against the
exterior surface of
the panel. Tighten
the bolts with a 1/2"
wrench to secure
the follower.
2. Attach the pocket
closure to the
follower using the
screws supplied
in the “Follower/
Pocket Closure”
screw package.
Fixed
panel
keeper
Jamb
Fixed panel
lock mechanism
drive
Jamb
Panel
Follower
Access
hole
Fixed panel
lock mechanism
drive
Panel
Access
hole
Panel
Closure
Fixed
panel lock
mechanism
drive
Pocket
closure
Panel