JELD-WEN JII104 Fiberglass Gliding Patio Doors with Applied Nailing Fin - Manual (Page 8)

INSTALLATION INSTRUCTIONS
for Fiberglass Gliding Patio Doors with Applied Nailing Fin (JII104)
8
8
COMPLETE INSTALLATION - CONTINUED
Lock Adjustment
Some locks will have a
single latch and some
will have a double
latch. Both adjust in the
same manner.
If the lock does not
properly engage the
strike plate:
• Loosen the strike
plate screws and
move up or down
until the latch
engages properly.
If the door does not
lock or is loose when
locked:
• Turn the latch
adjustment screw(s) in
1/2 turn increments:
clockwise to loosen or
counterclockwise to
tighten.
Lock hook adjustment
screw
Lock hook
adjustment
screw
Lock hook
adjustment
screw
Please visit www.jeld-wen.com for warranty, finishing instructions and care and maintenance information.
Thank you for choosing
AFTER INSTALLATION
• Install exterior wall
surface within seven
days of patio door
installation.
• Seal any gaps or
openings at end of
horizontal mull joints
with sealant.
• Insulate the void
between the rough
opening and the
frame with low
expansion foam.
Seal with backer rod
and sealant on the
exterior.
• Clean and finish all
exposed interior and
exterior parts of each panel with at least two topcoats of an exterior
grade finish. Primer alone is not a suitable barrier.
• Protect recently installed units from damage from plaster, paint, etc.
by covering the unit with plastic.
Backer rod
Gap
Sealant joint
©2014 JELD-WEN, inc.; This publication and its contents are owned by JELD-WEN, inc. and are protected under the U.S. Copyright Act and other
intellectual property laws. All trademarks, service marks, logos and the like (whether registered or unregistered) are owned or controlled by JELD-WEN,
inc. or others. Unauthorized use or duplication of JELD-WEN intellectual property is prohibited.
JELD-WEN reserves the right to change product specifications without notice. Please check our website, jeld-wen.com, for current information.
(05/14)