JELD-WEN JII105 Swinging French and Patio Doors User Manual
Page 5
INSTALLATION INSTRUCTIONS
for Swinging French and Patio Doors (JII105)
5
5. Cut two pieces of
JelD-WeN self-
adhesive flashing 6"
wide by the sill pan
width + 3" long.
a. For continuous
slab landings
only, cut out the
inside corner.
b. Adhere the pieces
of flashing to the
inside corners.
Stretch flashing
as needed to
cover corners and
lay flat.
6. Smooth gaps or
bubbles beneath
self-adhesive
flashing with a
J-roller (remove
and replace if
necessary).
7. Seal back corners of
sill pan with sealant.
8. For step-down
landings only, cut
plastic drain screen
to length of sill +
2" and staple 1/2"
below sill edge.
The drain screen
provides a path for
air to dry any incidental moisture in the rough opening.
END of Stud-Framed Wall Instructions continue with section 7 “INSTALL
DOOR.”
FOR RETROFIT INSTALLATIONS
Remove the old door. Remove sufficient siding to expose at least 9"
of intact building wrap. If damaged, apply new building wrap in a
shiplap manner. Verify header and trimmer studs are structurally sound.
Continue with instructions.
PREPARE BUILDING WRAP
Verify these steps do
not void the building
wrap manufacturer’s
warranty.
1. Trim building wrap
flush with the
edges of the rough
opening.
2. At the head, slit
building wrap 6"
at 45°. Tape up as
shown.
3. Apply spray
adhesive/primer
to the sill pan
and surrounding
area. Follow
manufacturer’s
instructions
for application
methods.
4. Cut a piece of
JelD-WeN self-
adhesive flashing
the length of the
sill and apply over
the sill pan as shown. The bottom of the sill pan should be completely
covered by the self-adhesive flashing. For step down landings, fold
flashing down as shown. For continuous slabs, trim flush with rough
opening.
6
PRePARe STUD - FRAMeD WAll
45˚
6"
Sill pan
width
3"
6"
Discard
(for
continuous
slab only)
Continuous Slab
Landing
Sill pan
width
3"
3"
Sealant
1"
1/2"
Step-Down
Landing
Sill pan
width
3"
3"
7
INSTAll DOOR
Warning!
To avoid injury, use at least two people to install. Adequately
support the door until completely fastened.
1. Apply a 3/8" bead of sealant where the back of the trim meets the
frame. Tool into a fillet shape. Run another bead of sealant along the
back of the fin/trim where it will contact the structure.
2. Tilt the door into
the rough opening,
making sure the
inside of the door sill
is fully seated into
the sealant on the sill
pan back dam.
3. Secure the door in
the rough opening
by pre-drilling holes
and then driving #8
x 3" drywall/deck
screws into the thick
part of the jamb
where shown. Do not
fully seat screws.
ShIM PATIO DOOR
Note!
Secure all shims
with sealant.
From the interior, shim
the head and side jambs
6" from the corners and
at 8" intervals. Install
shims at the strike
plate and at each hinge
location so the screws
(installed later) will
each penetrate a shim.
If installing a door with
a hinge jamb in the
middle, shim underneath
the mull for support.
Shim so the door is
square, level and plumb.
Verify there is a 1/8" margin between the frame and the door panels.
6"
6"
Strike
plate