JELD-WEN JII103 Bifold Doors - Manual (Page 9)

INSTALLATION INSTRUCTIONS
for Bifold Doors (JII103)
9
(08/12)
©2012 JELD-WEN, inc.; This publication and its contents are owned by JELD-WEN, inc. and are protected under the U.S. Copyright Act and other intellectual
property laws. All trademarks, service marks, logos and the like (whether registered or unregistered) are owned or controlled by JELD-WEN, inc. or others.
Unauthorized use or duplication of JELD-WEN intellectual property is prohibited.
JELD-WEN reserves the right to change product specifications without notice. Please check our website, jeld-wen.com, for current information.
Please visit jeld-wen.com for warranty, finishing instructions and
care and maintenance information.
Thank you for choosing
For best operational
performance and
aesthetic appeal,
install the door knob
in the center of the
middle rail of the lead
door(s) (panel without
pivot hardware). The
knob, however, can
also be installed in any
other location on the
lead door if desired.
Drill a hole slightly
smaller than the screw
and attach knob.
Note! Unless drilling the knob attachment hole close to an edge on a
hollow core door, it will likely be in a hollow part of the door. This does
not cause problems and the door material is sufficiently strong if the
screw is snug but not over tightened.
COMPLETE INSTALLATION
8
For four door
configurations, mount
an aligner as shown
on the back side of
each lead door.
Knob
Back side
of door
Back side
of door