King of Fans Belmont - Manual (Page 10)

Finishing the Fan
Installation
WARNING
WHEN USING THE STANDARD
BALL/DOWNROD MOUNTING, THE TAB IN
THE RING AT THE BOTTOM OF THE
MOUNTING PLATE MUST REST IN THE
GROOVE OF THE HANGER BALL. FAILURE
TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO
WIRING.
OPTION 1: STANDARD CEILING
MOUNTING
STANDARD CEILING MOUNTING
1. Align the holes of the ceiling
canopy with the screw holes in the
hanger bracket, secure them with the
screws removed in previous step.
2. You may now proceed to attaching
the fan blades.
OPTION 2: CLOSE-TO-CEILING
MOUNTING
1. Carefully unhook the fan from the
mounting plate and align the holes of the
ceiling canopy with the screw holes in
the hanger bracket, secure them with the
screws removed in previous step.
2. You may now proceed to attaching
the fan blades.
WARNING
LOCKING SLOTS OF CEILING CANOPY ARE
PROVIDED ONLY AS AN AID TO MOUNTING.
DO NOT LEAVE FAN ASSEMBLY
UNATTENDED UNTIL ALL FOUR CANOPY
SCREWS ARE ENGAGED AND FIRMLY
TIGHTENED.
Attaching the
Fan Blades
1. Attach blade to blade bracket and
decorative faceplate using the screws
and spring washers provided as shown in
Fig 15.
2. Tighten each screw securely.
3. Fasten the blade assembly to the fan
motor assembly by inserting the blade
bracket into the slot around the motor
housing and tightening the motor screws.
(Figure 16)
4. Repeat steps 1 2 & 3 for the
remaining blades.
Figure 15
Figure 16
8.