King of Fans Belmont - Manual (Page 9)

Making the Electrical
Connections
REMEMBER to shut the power off at
the circuit breaker or fuse box.
NOTE: (Fig.12) This remote control unit
is equipped with 16 code combinations to
prevent possible interference from or to
other remote units. The frequency switches
on your receiver and transmitter have been
preset at the factory. Please recheck to
make sure the switches on wall transmitter
and receiver are set to the same position,
any combination of settings will operate
the fan as long as the wall transmitter and
receiver are set to the same position.
Because the frequency switches are small,
please use a fine point instrument to adjust
the setting.
Step 1. (Fig.13) Insert the receiver into the
hanger bracket with the flat side of the
receiver facing the ceiling.
Step 2. Motor to Receiver Electrical
Connections: Connect the Black wire from
the fan to Black wire marked “To Motor
L” from the receiver. Connect the White
wire from the fan to the White wire
marked “To Motor N” from the receiver.
Connect the Blue wire from the fan to the
Blue wire marked “For Light” from the
Receiver. Secure wire connections with
the plastic wire nuts provided.
Step 3. (Fig.14) Receiver to House Supply
Wires Electrical Connections:
Connect the Black (hot) wire from the
ceiling to the Black wire marked "AC in
L" from the Receiver. Connect the White
(neutral) wire from the ceiling to the
White wire marked "AC in N" from the
Receiver. Secure wire connections with
the plastic wire nuts provided.
Step 4. If your outlet has a ground wire
(Green or Bare Copper), connect the fan
ground wires (on hanger ball and hanger
bracket) to it; otherwise, connect the fan
ground wire on hanger ball directly to
hanger bracket.
NOTE: Fan must be installed at a
maximum distance of 40ft from the
transmitting unit for proper signal
transmission between the transmitting unit
and the fan's receiving unit.
Fig 13
Fig 14
Fig 12
7.