Manley СORE REFERENCE CHANNEL STRIP - MCORE001-025 4/2014 - 5/2014 - Manual (Page 5)

c o r e
3. Front Panel
c o r e
REFERENCE CHANNEL STRIP
0
O/P 1 GR
O/P 2
LOW
0
-12 +12
dB MAX MIN
COMPRESSION
IN
BYPASS
FAST
ATTACK
SLOW FAST
COMPRESSOR
SLOW
RELEASE
INPUT
LEVEL
MIC
MIC
FLAT 0
180 120Hz HI
LOW LINE PHANTOM
48V
HANDCRAFTED IN CALIFORNIA USA
DIRECT IN
FREQUENCY
100Hz-1kHz
1kHz-10kHz
-10 +10 dB
0
MIN MAX
E Q
HI
-12 +12
dB
LIMITER
0
LIMIT
MAX
LIMITING
RELEASE
SLOW FAST
OUTPUT
GAIN
-6 +4
dB
!!
MIN
PREAMPLIFIER
Input Attenuator
Mic/Line
Source Select
High Pass Filter
High/Low Gain
Mic 48V Phantom
Mic Phase Invert
Instrument
Direct Input
COMPRESSOR
Attack
Release
Bypass
Compression
(Threshold)
EQ
High & Low Shelf
Sweepable Mid
Frequency
Low/High Range
Select
Continuously
Variable Frequency
Selection
LIMITER
Limiting/Threshold
Release
Fast Attack FET
Brickwall Limiter
Limit LED
Indicator
Output Gain
Control
VU METER
Meter Source
Select Switch
Displays Audio;
Compressor
Gain Reduction
Tube Preamp Out
Final Output
As the signal flow in the CORE is from right to left, we'll describe the functions in that order as well:
4. Input Section
Diagram 2
INPUT
LEVEL
MIC
MIC
FLAT 0
180 120Hz HI
LOW LINE PHANTOM
48V
HANDCRAFTED IN CALIFORNIA USA
DIRECT IN
The INPUT LEVEL control is an input attenuator, it functions like a
variable pad. It acts on the Direct In (DI), Mic and Line inputs. Fully
counter-clockwise is off, and clockwise rotation increases the gain. For
the Mic input, fully clockwise is about 40dB of gain, for the Line input,
it's about 20dB. With the gain switch set in the LOW position.
The top label of the selector switches are in operation when the button
is pushed in and illuminated.
MIC/LINE selects either the MIC input XLR or it selects the LINE or DI
inputs.
The 120Hz filter position is useful in reducing breath “pops,” or anytime
a reduction in bass response is desired.
The HI/LOW gain switch adds 20dB of gain to the circuit when engaged.
For most applications, this switch can be in the Low position, but for
low-output microphones, or quiet sources, extra gain may be needed.
48 Volt “PHANTOM” power is applied to the Mic input XLR when this
switch is engaged. This should only be used for microphones that
require phantom power.
0 0 0 180 - The Mic phase switch inverts the signal by 180 degrees when
engaged.
DIRECT IN, Instrument input. This 1/4 inch input jack is for use with
guitars, keyboards, or any other instrument. When a jack is inserted
the CORE will automatically switch to the DI input. The Mic/Line switch
must be set to the Line position to activate the DI. This is an
unbalanced 10 Megohm input, that will not load down Hi Z instruments
like guitar. The connections on the TS Jack are TIP-HOT, SLEEVE-
GROUND.
!
4