Mc Leod Original Street Twin - Manual (Page 2)

2
3) Remove top disc and alignment tool. Notice the hub on the disc is cupped toward the transmission.
Also note the “Flywheel Side” sticker on the disc center. See Figure 2
Figure 2
4) Remove the three nuts that hold the floater straps onto the flywheel. Remove the floater assembly.
Note the straps on the floater are on the flywheel side. Do not remove the straps from the floater!
There are six large studs and three small studs in the flywheel. There is a series of spacers (stands)
and shims on these studs. Do not mix these parts. Install nuts onto studs to prevent the spacers
and shims from falling off the studs during flywheel installation!
5) Remove the bottom disc. Notice the hub on the disc is cupped toward the transmission. Also note
the “Flywheel Side” sticker on the disc center. See Figure 3
Figure 3