Nitrous Express Speed3000 R/C Vehicle Nitrous System User Manual
Page 3
7. Follow the wiring diagram below, solder and wrap all connections with heat shrink
to complete the install. The nitrous solenoid in this system is DC, so any wire can be
chosen as power or ground wire.
8. Once all connections are secured, test the system by arming the master arming
switch and activating the throttle servo until wide-open throttle is achieved, the
nitrous solenoid should click as the throttle linkage causes the micro switch to be
engaged.
9. Once all steps are completed be sure all fittings, nuts and bolts are tight. Re-install
any covers or clips that were removed during the installation process.
10. After we have assured the system is functioning properly it is time to open the
previously filled bottle and have some fun!