Nitrous Express Water Methanol Stage 3 - Manual (Page 6)

Screen 6C
EFI FULL INCREASE
This screen sets the fuel injector PW full point when maximum injection through the nozzle will be reached.
Typical EFI full points are 60-80%.
Screen 6D
EFI FULL DECREASE
This screen sets the fuel injector PW full point when maximum injection
through the nozzle will be reached.
Screen 7A
BOOST START INCREASE
This screen sets the boost pressure required to start injection through the nozzle. This should be set at a boost
that just above normal driving. IF you hit 5 psig leaving a stop light normally, set this to 7 psig.
Screen 7B
BOOST START DECREASE
This screen sets the boost required to start injection.
Screen 7C
BOOST FULL INCREASE
This screen sets the boost full point when maximum injection through the nozzle will be reached. In most ap-
plications, this should be set at a boost achieved at WOT in hard driving.
Screen 7D
BOOST FULL DECREASE
This screen sets the boost full point when maximum injection through the nozzle will be reached.
Screen 8A
PW/BOOST CONTROL INC
This screen adjusts the balance between boost and PW based injection. Pressing button 2 will increase the PW
importance and decrease the boost importance by 1%. If it is set at 50/50, then PW and boost are weighted
equally to determine how much to inject at any given time. The weighting can be adjusted in 1% increments.
50/50 is often a good starting point.
EFI Full%
Increase--------
EFI Full%
Decrease--------
Boost Start
Boost Start
Decrease--------
Increase--------
Boost Full
Boost Full
Decrease--------
Increase--------
PW/Boost Control
Increase--------