Quick Fuel Technology 30-7301 300 FUEL PUMP REBUILD KIT - Manual

QFT™ 300 FUEL PUMP REBUILD KIT
P/N 30-7301
1. Remove (3) assembly fasteners, lower wear plate, rotor, o-ring, eccentric bushing, upper wear plate, bypass plug, valve spring,
and piston.
2. Place the new upper wear plate in the pump body positioned around the existing alignment pin.
3. Install the eccentric bushing to position on the same alignment pin.
4. Install the rotor on the shaft with the counter bore facing out.
5. Install the vanes into each slot in the rotor.
6. Install the new o-ring.
7. Position the new lower wear plate and torque the (3) screws to 40 -60 in./lbs.
8. Install the new piston, new spring, and o-ring on the bypass plug.
9. Torque the bypass plug to 40-60 in./lbs.
30-7306 (QFT 300 Body Kit) INSTALLATION:
1. Remove (2) motor screws and slide motor out. CAUTION! HOLD MOTOR END CAPS AGAINST MOTOR HOUSING DURING
AND AFTER SEPARATION.
2. Carefully insert motor shaft through new fuel pump body assembly.
3. Torque the (2) screws to 15-20 in./lbs.
Figure 1
Quick Fuel Technical Support: 1-270-793-0900
For warranty information, please see our website at www.quickfueltechnology.com .
99-30-7301
Revision Date: 10-2-13