Quick Fuel Technology 30-7300 230 & 260 FUEL PUMP REBUILD KITS - Manual

QFT™ 230 & 260 FUEL PUMP REBUILD KITS
P/N 30-7300
1. Remove (4) assembly fasteners, mounting bracket, lower wear plate, rotor, o-ring, eccentric bushing, upper wear plate, and bypass valve assembly.
2. Disassemble the bypass valve and examine for debris and smooth movement of the piston.
3. Replace the internal and external o-rings.
4. Place the new upper wear plate in the pump body positioned around the existing alignment pin.
5. Install the eccentric bushing to position on the same alignment pin and against the upper wear plate.
6. Install the rotor on the shaft with the counter bore facing out.
7. Install the vanes into each slot in the rotor.
8. Install the new o-ring.
9. Position the new lower wear plate and torque the (4) screws to 20 -30 in./lbs.
30- 7305 (QFT™ 230 Body Kit) & 30-7313 (QFT™ 260 Body Kit) INSTALLATION:
1. Remove (2) motor screws and slide motor out. CAUTION! HOLD MOTOR END CAPS AGAINST MOTOR HOUSING DURING AND AFTER
SEPARATION.
2. Carefully insert motor shaft through new fuel pump body assembly.
3. Torque the (2) screws to 10-13 in./lbs.
Figure 1
Quick Fuel Technical Support: 1-270-793-0900
For warranty information, please see our website at www.quickfueltechnology.com .
99-30-7300
Revision Date: 10-2-13