Rocky Mountain Radar KAT500 - Manual (Page 5)

POWER AND VOLUME CONTROL
To turn on the detector, connect power and
rotate the wheel controller. You can also use
the controller to adjust the volume level by
turning it up or down.
Note : Turning on the detector will trigger the Self-
Test mode.
BRIGHTNESS CONTROL
Press Dim Button. An audible warning sound
w i l l a l e r t y o u t h a t D i m m o d e h a s b e e n
activated. Each time you press Dim button,
display intensity will change dim, dark, bright.
CITY / HIGHWAY MODE
The false-alert are often caused in urban areas
by automatic door openers and alarm systems.
Press the City Button. “City” LED turns on for
“ C i t y ” M o d e . I n C i t y m o d e , X b a n d i s n o t
detected and K/Ka band sensitivity is lowered.
Caution : Some towns and small cities may still
be using X band radar
- 8 - - 9 -
MUTE MODE
Mute can be used when you manually turn the audio
alert off. Press Mute Button to silence the audio.
Note : Press button again to restore audio alarm. The
KAT500 can not activate Mute and Dark at
same time. If the Mute is engaged, the Dark
can not activate.
SELECT TONE
Hold down the Mute button for three seconds.
The KAT500 will change tone.
INDICATOR AND VISUAL
a. Power On
“P” LED turns on.
b. X Band Detection
“X” LED turns on with audible tone.
c. K/Ka Band Detection
“K/Ka” LED turns on with audible tone.
OPERATION