Rocky Mountain Radar KAT500 - Manual (Page 8)

- 14 - - 15 -
This unit guaranteed against defects in workmanship and materials for
one year. Should you experience any difficulty with the KAT500 during
this time, the unit will be repaired or replaced at no charge. Should you
desire to have your unit checked, there will be no additional charge other
than postage and handling. After the warranty period expires, the unit
may be returned for service and it will be reconditioned for 25.00
WARRANTY
FCC INFORMATION
This product has been designed and certified to comply with Part 15 of
the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by K. A. T. may
void your authority to use this product.
RADAR
Receiver Type : Dual conversion Superheterodyne
Antenna Type : Linear polarized, Self-Contained Antenna
Detector Type : Scanning Frequency Discriminator
Frequency of Operation : 10.525GHz/
50MHz(X-Band)
24.150GHz/ 100MHz(K-Band)
34.700GHz/ 1,300MHz
(Ka Super Wideband)
LASER
Receiver Type : Pulsed Laser Signal Receiver
Detector Type : Digital Signal Processor Pulse Width Discriminator
Opto Sensor : Dual Convex Condenser Lens and High Speed Photo
Diode Detector
Spectral Response : 800 ~ 1,100nm
GENERAL
Temperature Range : -4 to 158
(-20 to 70 )
Power Requirements : 12 ~ 15V DC, 80 nominal (Negative Ground)
Dimensions(HWD) : 1.1” x 2.5” x 3.6”
Weight : 2.2oz
Specifications are typical : individual units might vary.
Specifications are subject to change without notice.
SPECIFICATION