Rocky Mountain Radar KAT600 - Manual (Page 8)

- 15 - - 14 -
RADAR
Receiver Type : Dual conversion Superheterodyne
Antenna Type : Linear polarized, Self-Contained Antenna
Detector Type : Scanning Frequency Discriminator
Frequency of Operation : 10.525GHz/
50MHz(X-Band)
24.150GHz/ 100MHz(K-Band)
34.700GHz/ 1,300MHz(Ka Super Wideband)
LASER
Receiver Type : Pulsed Laser Signal Receiver
Detector Type : Digital Signal Processor Pulse Width Discriminator
Opto Sensor : Dual Convex Condenser Lens and High Speed Photo
Diode Detector
Spectral Response : 800 ~ 1,100nm
GENERAL
Temperature Range : -4 to 158
(-20 to 70 )
Power Requirements : 12 ~ 15V DC, 80 nominal (Negative Ground)
Dimensions(HWD) : 1.1” x 2.5” x 3.6”
Weight : 2.2oz
Specifications are typical : individual units might vary.
Specifications are subject to change without notice.
SPECIFICATION
HOW DOES THE LASER SCRAMBLER WORK?
Lider sends out laser pulses and measures how long it takes to hit your
car and come back. From the speed of light it can determine your range.
It sends out several more pulses and calculates your speed from the
change in distance over time. The KAT600 transmits pulses
electronically timed at 100 feet apart. This only allows the Lidar to see
up to 100 feet so it is unable to calculate your speed.
LASER SCRAMBLER SELECT :
Turn Power OFF; Press and hold “CITY” button while turning ON the
detector(power-on) to select laser scrambler. Factory default is laser
scrambler on. The “L” LED will light up when the laser scrambler is on.
The “L” LED will turn off when the laser scrambler is off. To turn
scrambler back ON, repeat above steps.
COMPLETE TICKET REBATE REGISTRATION CARD AND
MAIL TO K.A.T. INC. WITHIN 30 DAYS.
WARRANTY
This product has been designed and certified to comply with Part 15 of
the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by K. A. T. may
void your authority to use this product.
FCC INFORMATION
The KAT600 guaranteed against defects in workmanship and materials
for one year. Should you experience any difficulty with the KAT600
during this time, the unit will be repaired or replaced at no charge.
Should you desire to have your unit checked, there will be no additional
charge other than postage and handling. After the warranty period
expires, the unit may be returned for service and it will be reconditioned
for 25.00