Sper Scientific 840051 Datalogger User Manual
Page 4
4
FRONT PANEL DESCRIPTION
1. LED TIME SETTING DISPLAY
2. FULL INDICATOR
3. DATA FLOW INDICATOR
4. PAUSE INDICATOR
5. POWER/LOW BATTERY INDICATOR
6. AUTO/MANUAL/OUT SWITCH
7. TIME SWITCH (Seconds, Minutes,
Hours)
8. ON/OFF SWITCH
9. RESET/INC. 10 BUTTON
10. PAUSE/INC. 1 BUTTON
11. SET BUTTON
12. uP INPUT SOCKET
13. uP OUTPUT SOCKET
14. DMM INPUT SOCKET
15. DMM OUTPUT SOCKET
13
3. With the DATALOGGER off, set the AUTO/
MAN/OUT switch to “OUT”. Turn the
DATALOGGER on.
4. Click the “OK” button on the computer.
5. Click the correct com port in the lower left corner
of the window.
6.
Click the “Read DATALOGGER” button.
•
Immediately, press the “RESET” button (Fig.1-9)
to upload data. The “DATA” indicator (Fig.1-3)
USING DATA LAB SOFTWARE
WITH THE DATALOGGER
1. Start DATA LAB software and select the “Go to
DATALOGGER Program” button.
2. Plug the earphone plug into the “uP OUT”
socket on the DATALOGGER. Plug the 9 pin
plug into the serial port of the computer (if your
computer has a 25 pin serial port, you may
require an adapter available at most computer
stores).
Figure 3