Sper Scientific 840064 Vacuum Meter User Manual

Page 4

Advertising
background image

- 4 -

3. OPERATING INSTRUCTIONS - See item 2 on page 3 for button

locations and description.


3-A. NOTES - READ BEFORE FIRST USE

•

Do not insert objects into the Sensor Input (9) or the diaphragm
can be damaged and the warranty voided.

•

The sensor is compatible with industrial gases and liquids that are
also compatible with ceramic material.

•

The sensor must be attached to the meter in order to display the
ambient barometric pressure (in/Hg). Otherwise, "0" will be dis-
played.

•

3-B. MEASUREMENT PROCEDURES

•

Connect the Probe Plug (11) to the meter's Input Socket (4).

•

Press the Power (2) button to turn on the meter.

•

Press the Unit (7) button to select one of the eight units of measure:
torr, mm Hg, micron (

uH9), mbar, KPa (- - PA), PA, inch Hg (in/Hg),

or PSI.

•

Remove the protective cap and connect the threaded Sensor Input
(10) to the vacuum source to be measured.

•

The measurement will appear on the Display (5).


3-C. HOLD

•

Press the Hold (6) button during measurement to freeze the
displayed reading. "HOLD" and the reading are displayed.

•

Press the Hold (6) button a second time to resume measurement.


3-D. MAXIMUM / MINIMUM RECORDING

•

Press the Max/Min (3) button once. The LCD display will indicate
"REC" as the data recording function begins.

•

Press the Max/Min (3) and "REC Max" (along with the maximum
recorded reading) will appear on the LCD display.

•

Press the Max/Min (3) again and "REC Min" (along with the
minimum recorded reading) will appear on the display.

•

Press and hold the Max/Min (3) for approximately 2 seconds to exit
this function and resume measurment.

Advertising