Turbo Action 17999 Torqueflite 727, 904, 998 & 999 Tranz Brake (PRN123) - Manual (Page 3)

Part #17999 3/31/04 Page #3
Special characteristics about your CHEETAH Valve Body:
1. First Gear - no gear braking.
2. First to second shift on jackstands will not be noticeable.
3. Line pressure can be read at the middle plug on passenger’s side. Suggest a
200. PSI gauge, our Part #00107.
Positively Do Not make any modifications other then those suggested in these instructions.
See page #10 for additional info for Pro Light Racing.
CAUTION: Do Not Neutral Transmission till under 2500 RPM.
Very Important!!
You must use a single hole type filter with this valve body.
Deep pan:
Must be a single hole pick-up.
Installation Instructions
FIRST, READ INSTRUCTIONS CAREFULLY, THEN PROCEED TO INSTALL VALVE BODY
PER THESE INSTRUCTIONS.
Kit Includes:1 - 17999 Valve Body
1 - 17387-4 Solenoid (Installed on Valve Body)
1 - 17388
Case Connector
1 - 17389 Wire Snap Plug Connector
1 - 17390 Wire Restraint
1 - 00690 7/16” Drill w/1/4” Shank
1 - 00691 1/4” Pipe Tap
1 - 17270C Pan Gasket “727”
1 - 19063C Pan Gasket “904”
1 - 17013
Dacron Filter Single Hole 1966-91
Note: Must use single hole filter
1 - 17014 Filter Gasket (Use with deep pan filter extension. )
1 - 17131A ACC. Piston Blocker
1 - 17396
Rear Servo Shim
STEP #1: If vehicle is on the ground, secure so it will not roll, (Preferably, vehicle should
have all four wheels off the ground.) Place vehicle shift selector in park range.
Remove throttle pressure linkage and gear selector linkage located on the driver’s
side of the vehicle. Disconnect only at the shaft coming out of the transmission
case. You will note the two linkage levers on the shaft are fastened by a bolt in
each case. Loosen these bolts completely. After loosening bolts, carefully pry
levers upward with a screwdriver. The top throttle pressure lever is no longer
needed.