Tuff Country 14059 - GM 2014 Silverado 1500 4wd 4 lift kit User Manual
Page 5
10. Using a die grinder, carefully notch out the OE cross
member following the lines that were scribed earlier.
11. Install the newly modified rear cross member back into
the OE location using the OE hardware. Make sure to loc-
tite and torque to 45 ft lbs. Special note: Check and dou-
ble check to make sure that the front differential is not
making contact with the modified cross member. If con-
tact occurs, take more material off of the cross member
until clearance is achieved.
12. Working on the driver side, remove the ABS line from the
bracket on the top of the upper control arm pocket. Now dis-
connect the ABS lines from each other at the quick discon-
nect. Special note: Take special care not to damage ABS
line during removal. Repeat procedure on the passenger
side.
13. Working on the driver side, remove the ABS line from the
OE upper control arm. The hardware maybe discarded.
Carefully remove the bracket from the ABS line and brake
line and set aside. Repeat procedure on the passenger side.