Yetter 2984 High Residue Maverick Opener - Manual (Page 13)

13
ASSEMBLY INSTRUCTIONS
2984-020, 2984-021, 2984-022 – RESIDUE MANAGER
STEP 1. Assemble the residue manager wheel to the 2965-352-hub cap and the 2965-128-hub/bearing
assembly. Insert the D-bolt through the 1.50 O.D. x 21/32” I.D. x 3/16” thick flat washer, then through the
hub/bearing assembly. Use 4) 5/16 x 1-½ carriage bolts and 5/16-18 lock nuts per wheel.
NOTE: Assemble one wheel as a right hand wheel rotation and one wheel as a left hand wheel rotation.
IMPORTANT. The 2527-530 washer must be installed or the wheel and hub assembly will fall off
during use.
NOTE: Be certain to align the grease zerk with the slot in the wheel and the hub cap so that the grease can
flow freely.
STEP 2. Attach the wheel assemblies to the 2967-200-stem bracket through the rear holes of the stem.
NOTE: The rotation of the wheel, left hand wheel assemblies mount to L.H. side of the stem and the right
hand wheel assemblies mount to the R.H. side of the stem. Torque 150 ft.lbs.
TORQUE 150 FT.LBS.